From: Tom Wigley To: santer1@llnl.gov Subject: Re: Our d3* test Date: Wed, 28 May 2008 21:58:34 -0600 Cc: "Thorne, Peter" , Leopold Haimberger , Karl Taylor , Tom Wigley , John Lanzante , "'Susan Solomon'" , Melissa Free , peter gleckler , "'Philip D. Jones'" , Thomas R Karl , Steve Klein , carl mears , Doug Nychka , Gavin Schmidt , Steven Sherwood , Frank Wentz Dear all, Just to add a bit to Ben's notes. The conceptual problem is how to account for two different types of uncertainty in comparing a single observed trend (with temporal uncertainty) with the average of a bunch of model trends (where the uncertainty is from inter-model differences). The "old" d3 tried to do this, but failed the synthetic data test. The new d3 does this a different way (in the way that the inter-model uncertainty term is quantified). This passes the synthetic data test very well. The new d3 test differs from DCSP07 only in that it includes in the denominator of the test statistic an observed noise term. This is by far the bigger of the two denominator terms. Ignoring it is very wrong, and this is why the DCSP07 method fails the synthetic data test. Tom. ++++++++++++++++++++++++ Ben Santer wrote: > Dear folks, > > Just wanted to let you know that I did not submit our paper to IJoC. > After some discussions that I've had with Tom Wigley and Peter Thorne, I > applied our d1*, d2*, and d3* tests to synthetic data, in much the same > way that we applied the DCPS07 d* test and our original "paired trends" > test (d) to synthetic data. The results are shown in the appended Figure. > > Relative to the DCPS07 d* test, our d1*, d2*, and d3* tests of > hypothesis H2 yield rejection rates that are substantially > closer to theoretical expectations (compare the appended Figure with > Figure 5 in our manuscript). As expected, all three tests show a > dependence on N (the number of synthetic time series), with rejection > rates decreasing to near-asymptotic values as N increases. This is > because the estimate of the model-average signal (which appears in the > numerator of d1*, d2*, and d3*) has a dependence on N, as does the > estimate of s{}, the inter-model standard deviation of trends > (which appears in the denominator of d2* and d3*). > > The worrying thing about the appended Figure is the behavior of d3*. > This is the test which we thought Reviewers 1 and 2 were advocating. As > you can see, d3* produces rejection rates that are consistently LOWER > (by a factor of two or more) than theoretical expectations. We do not > wish to be accused by Douglass et al. of devising a test that makes it > very difficult to reject hypothesis H2, even when there is a significant > difference between the trends in the model average signal and the > 'observational signal'. > > So the question is, did we misinterpret the intentions of the Reviewers? > Were they indeed advocating a d3* test of the form which we used? I will > try to clarify this point tomorrow with Francis Zwiers (our Reviewer 2). > > Recall that our current version of d3* is defined as follows: > > d3* = ( b{o} - <> ) / sqrt[ (s{} ** 2) + ( s{b{o}} ** 2) ] > > where > > b{o} = Observed trend > <> = Model average trend > s{} = Inter-model standard deviation of ensemble-mean trends > s{b{o}} = Standard error of the observed trend (adjusted for > autocorrelation effects) > > In Francis's comments on our paper, the first term under the square root > sign is referred to as "an estimate of the variance of that average" > (i.e., of <> ). It's possible that Francis was referring to > sigma{SE}, which IS an estimate of the variance of <>. If one > replaces s{} with sigma{SE} in the equation for d3*, the > performance of the d3* test with synthetic data is (at least for large > values of N) very close to theoretical expectations. It's actually even > closer to theoretical expectations than the d2* test shown in the > appended Figure (which is already pretty close). I'll produce the > "revised d3*" plot tomorrow... > > The bottom line here is that we need to clarify with Francis the exact > form of the test he was requesting. The "new" d3* (with sigma{SE} as the > first term under the square root sign) would lead to a simpler > interpretation of the problems with the DCPS07 test. It would show that > the primary error in DCPS07 was in the neglect of the observational > uncertainty term. It would also simplify interpretation of the results > from Section 6. > > I'm sorry about the delay in submission of our manuscript, but this is > an important point, and I'd like to understand it fully. I'm still > hopeful that we'll be able to submit the paper in the next few days. > Many thanks to Tom and Peter for persuading me to pay attention to this > issue. It often took a lot of persuasion... > > With best regards, > > Ben > > ---------------------------------------------------------------------------- > > Benjamin D. Santer > Program for Climate Model Diagnosis and Intercomparison > Lawrence Livermore National Laboratory > P.O. Box 808, Mail Stop L-103 > Livermore, CA 94550, U.S.A. > Tel: (925) 422-2486 > FAX: (925) 422-7675 > email: santer1@llnl.gov > ---------------------------------------------------------------------------- >